Section 1 - General Information
1-25 1-25
1-05-01 Issue 02
Torque Settings
Introduction
This topic contains information about torques. Torque values are given for types and sizes of bolts and hydraulic
connectors and adaptors.
Where a torque is given as a single figure it may be varied by plus or minus 3%. Torque figures are given for fasteners
with different surface treatments. Make sure you use the correct torque figures.
Where torques are given in topics within the other sections always use these values.
K
Zinc Plated Fasteners and Dacromet Fasteners ( T 1-26)
K Introduction ( T 1-26)
K Bolts and Screws ( T 1-26)
K Hydraulic Connections ( T 1-30)
K 'O' Ring Face Seal System ( T 1-30)
K 'Torque Stop' Hose System ( T 1-36)
K `Positional Type' Hydraulic Adaptors ( T 1-37)
K Fitting Procedure ( T 1-37)
To Next Page
Loading...
Need help?
General
