About the Product
Product and Component Identification
11 9821/3250-5 11
Table 5. Example of the engine identification number
SD 320/40001 U 00001 04
Digit 1-2 3-10 11 12-16 17-18
Table 6. Explanation of the engine identification number
Digit Explanation
1-2 Engine type. SH = 4.4L electronic com-
mon rail fuel injection tier 4i. SD = 4.4L
mechanical fuel injection tier 3. SE =
4.4L electronic common rail fuel injec-
tion tier 3. DE = 4.8L electronic common
rail fuel injection tier 2. EK = 7.2L elec-
tronic common rail fuel injection tier 2
3-10 Engine part number
11 Country of manufacture. U = United
Kingdom
12-16 Engine serial number
17-18 Year of manufacture
The country of manufacturer, engine serial number and year of manufacture of the engine are also stamped
on the cylinder block. Refer to Figure 7.
Operator Protective Structure
WARNING Machines with a ROPS, FOPS,FOGS or TOPS are equipped with a seat belt. The ROPS,
FOPS,FOGS or TOPS is designed to give you protection in an accident. If you do not wear the seat belt you
could be thrown off the machine and crushed. You must wear a seat belt when using the machine. Fasten
the seat belt before starting the engine.
WARNING Modified and wrongly repaired ROPS, TOPS and FOGS are dangerous. Do not modify the
TOPS. Do not attempt to repair the ROPS, TOPS and FOGS. If the ROPS, TOPS and FOGS has been in
an accident, do not use the machine until the structure has been examined and repaired. This must be done
by a qualified person. For assistance, contact your JCB dealer. Failure to take precautions could result in
death or injury to the operator.
FOGS Data Plate
WARNING Do not use the machine if the falling objects protection level provided by the structure is not
sufficient for the application. Falling objects can cause serious injury.
If the machine is used in any application where there is a risk of falling objects then a FOGS (Falling Object
Guard System) must be installed. For further information, contact your JCB dealer.
Each element of the FOGS has a data plate attached. The data plate indicates what level of protection the
structure provides.
There are two levels of FOGS:
• Level I Impact Protection - impact strength for protection from small falling objects (e.g. bricks, small
concrete blocks, hand tools) encountered in operations such as highway maintenance, landscaping and
other construction site services.
• Level II Impact Protection - impact strength for protection from heavy falling objects (e.g. trees, rocks) for
machines involved in site clearing, overhead demolition or forestry.
To Next Page
Loading...
Need help?
General
