Operation
Stopping and Parking
24 9831/3200-3 24
Stopping and Parking
General
This machine has brakes installed on the rear wheels only. The brakes installed on this machine are park brake
only, there are no dynamic brakes installed.
The brake will release automatically during travel, the brake will not release during lifting.
1. Select a safe place to stop where the ground is firm and level such as slabbed or paved surface, where
the machine will not cause an obstruction and away from heavy traffic.
2. Lower the platform.
3. Turn the key switch to the off position. Remove the key to avoid unauthorized use.
3.1. Before switching off the machine check the battery level. If necessary, put the machine on charge to
ensure that the battery is fully charged for the next time the machine is used.
Brake Operational Limits
The machine brakes are capable of stopping the machine at its maximum speed on the maximum gradients
as stated in this manual.
It is recommended that the machine is not parked or left unattended on slopes greater than those specified
in this manual. It is the responsibility of the operator to assess the ground and atmospheric conditions before
using or parking the machine on gradients.
The machine must be immediately taken out of service until corrected if the brakes do not operate within
specifications or performance requirements as defined in this manual or any other in-service, periodic or post-
maintenance brake verification.
To Next Page
Loading...
Need help?
General
