EasyManuals Logo
Home>Jeep>Automobile>2009 Commander

Jeep 2009 Commander User Manual

Jeep 2009 Commander
488 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #201 background imageLoading...
Page #201 background image
Engine Oil Change Indicator System
Oil Change Required
Your vehicle is equipped with an engine oil change
indicator system. The “Oil Change Required” message
will flash in the EVIC display for approximately 10 sec-
onds after a single chime has sounded to indicate the next
scheduled oil change interval. The engine oil change
indicator system is duty cycle based, which means the
engine oil change interval may fluctuate dependent upon
your personal driving style.
Unless reset, this message will continue to display each
time you turn the ignition switch to the ON/RUN
position. To turn off the message temporarily, press and
release the MENU button. To reset the oil change indica-
tor system (after performing the scheduled maintenance)
refer to the following procedure.
1. Turn the ignition switch to the ON position (Do not
start the engine).
2. Fully depress the accelerator pedal slowly three times
within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.
NOTE: If the indicator message illuminates when you
start the vehicle, the oil change indicator system did not
reset. If necessary repeat this procedure.
Trip Functions
Press and release the MENU button until one of the
following Trip Functions displays in the EVIC:
Average Fuel Economy
Distance To Empty
Trip A
Trip B
Elapsed Time
Service Distance
Display Units of Measure In
UNDERSTANDING YOUR INSTRUMENT PANEL 199
4

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jeep 2009 Commander and is the answer not in the manual?

Jeep 2009 Commander Specifications

General IconGeneral
BrandJeep
Model2009 Commander
CategoryAutomobile
LanguageEnglish

Related product manuals