Jeep 2009 Commander User Manual

Rear Tail, Stop, Turn Signal, and Backup Lights
1. Raise the liftgate.
2. Remove the two push-pins that secure the rear lamp
unit to the side of the liftgate opening.
3. Pull the outboard side of the rear lamp unit rearward
far enough to unsnap the two ball studs on the outboard
side of the lamp housing from the two plastic grommets
in the quarter outer panel. Pull the lamp unit rearward
far enough away to access the bulbs.
MAINTAINING YOUR VEHICLE 433
7

Jeep 2009 Commander Specifications

General

Brand	Jeep
Model	2009 Commander
Category	Automobile
Language	English