AWM968
5
USB Interface Connector
You can connect a USB device directly to USB interface (20) on the front of the AWM968 for
playback of compatible files. Playback begins automatically. Press the DVD/USB button (8) to
switch to USB mode from another source. Refer to “MP3/USB Operation” on page 11 for
additional operating instructions.
NOTE: USB will not support Apple device playback or charging.
Clock Display
Press the T/F button (25) to alternate between playing time and clock time while in Tuner, CD,
DVD, USB or auxiliary input mode.
Clock Setup
Press and hold the CLOCK HR button (11) to adjust the hour. Continue adjusting the hour to
move from AM to PM. Press and hold the CLOCK MIN button (12) to adjust minutes. The new
time will be saved five seconds after the last adjustment is made.
Setting the Sleep Time
The Sleep Timer will automatically turn off the AWM968 in the designated number of minutes.
To set the Sleep Time, press the ALARM SET button (17) and the sleep time will appear in the
display with the number representing the minutes (SLEEP 0). Press ALARM SET repeatedly
to change the sleep time from 15 to 30, 45 or 60 minutes.
Setting the Alarm
To set the alarm, press and hold the ALARM SET button (17). The clock digits will flash.
Repeatedly press the HR button (11) to adjust the hour one digit at a time, or press and hold to
advance rapidly. Repeatedly press the MIN button (12) to adjust the minutes one digit at a
time, or press and hold to advance rapidly. Press the ALARM SET button (17) to save the
alarm time.
Once a time is set, press ALARM ON/OFF (16) to turn the alarm function on or off.
Speaker Output
The three speaker output buttons (22) (A SPEAKER, B SPEAKER and C SPEAKER) control
speaker output from the radio. Press any of the three buttons to turn the corresponding
speaker sets on or off. SPK A, SPK B or SPK C will appear on the display.
Reset
The reset button should be activated for the following reasons:
• initial installation of the unit when all wiring is completed
• function buttons do not operate
• error symbol on the display
Use a ball point pen or similar object to press the reset button (4). This may be necessary
should the unit display an error code.
To Next Page
Loading...
Need help?
General
