7
BATT audible tone.
• LCD BRIT (01 – 10): Adjust LCD brightness.
• BT ON/OFF: Choose “BT ON” or “BT OFF”.
• BT PAIR (ON/OFF): Choose “YES” to automatically pair a previously paired
device.
• BT DEVICE (Lock/Unlock, Disconnect/Connect, Delete): View, lock and
delete from a list of previously paired mobile phone device models.
• RESET: Return the EEPROM to factory default set up values. "RESET" will
appear on the LCD. To confirm press the ENTER button (18).
NOTE: BT Pair and BT Device menu options are only available while in the
BT mode.
LOW BATTERY Operation
If LOW BATT is set to “ON”, an alarm will sound (8 beeps every 30 sec) when the
voltage drops to 10.8V (+/- 0.3V). A visual warning (LOBA) will appear flashing (8
flashes every 30 sec) in the lower left corner of the LCD display.
NOTE: “OFF” is the default setting for LOW BATT. If the audio is muted or
the volume is set to 0, the audible beep will not be heard.
Equalizer
Press the EQ/LOUD button (11) to turn on the equalization function and select
between five pre-defined bass and treble curves: USER > FLAT > POP > CLAS >
ROCK.
Loudness
Press and hold the EQ/LOUD button (11) to toggle true loudness on/off. When
listening to music at low volumes, this feature will boost the bass and treble
ranges to compensate for the characteristics of human hearing.
Auxiliary Input
To access an auxiliary device:
1. Connect the portable audio player to the AUX IN cables routed from the rear
of the radio.
2. Press the MODE button (4) until the AUX option is shown.
3. Press MODE again to cancel Aux In mode and switch to the next mode.
Liquid Crystal Display (LCD)
The current frequency and activated functions are shown on the LCD panel (20).
NOTE: LCD panels may take longer to respond when subjected to cold
temperatures for an extended period of time. In addition, the visibility of the
numbers on the LCD may decrease slightly. The LCD display will return to
normal when the temperature increases to a normal range.
Quick Exit Hot Key
In the following modes and conditions, press the AS/PS button (15) < 3
seconds to quickly exit the current operation without waiting for the system default
time out:
• System menu operation
• Searching mode
• Audio menu operation
To Next Page
Loading...
Need help?
General
