8
TUNER OPERATION
Select a Band
Press the BAND/SEARCH button (16) to change between three FM bands and
two AM (MW) bands.
Manual Tuning
Press the ►►or◄◄ buttons (14, 13) to seek stations up/down step by step.
Auto Seek Tuning
Press and hold the ►►| SEEK/TUNE/TRK or |◄◄ SEEK/TUNE/TRK buttons
(14, 13) to automatically seek the next or previous strong station.
Preset Stations
Six numbered preset buttons store and recall stations for each band.
Store a Station
Select a band (if needed), then select a station. Press and hold a preset button
(5-10) for two seconds. The preset number will appear in the display.
Recall a Station
Select a band (if needed). Press a preset button (5-10) to select the corresponding
stored station.
Automatically Store / Preset Scan (AS/PS )
Automatically Store
Select a band (if needed). Press and hold the AS/PS button (15) for more than
three seconds to automatically select six strong stations and store them in the
current band. The new stations replace any stations already stored in that band.
NOTE: During Auto Store (AS), the tuner will default to “Local” mode while
scanning the band initially. After scanning the entire band once, the unit will
switch to “Distant” mode for all subsequent Auto Store tuning.
Preset Scan
Select a band (if needed). Press the AS/PS button (15) to scan stations stored
in the current band. The unit will pause for ten seconds at each preset station.
Press AS/PS again to stop scanning when the desired station is reached.
To Next Page
Loading...
Need help?
General
