EasyManuals Logo
Home>Johnson Controls>Thermostat>FCP-NA-701

Johnson Controls FCP-NA-701 User Manual

Johnson Controls FCP-NA-701
10 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
FCP-NA-701, FCP-PA-701
www.johnsoncontrols.com
Building Technologies & Solutions
Headquarters: Milwaukee, Wisconsin, USA
Branch Offices: Principal Cities World-wide
© Copyright 2020 Johnson Controls.
All specifications and other information shown were current as of document revision and are subject to change without notice.
This product is covered by a limited warranty, details of which can be found at
www.johnsoncontrols.com/buildingswarranty.
Product warranty
Contact information
Contact your local branch o󰀩ce: www.johnsoncontrols.com/locations
Contact Johnson Controls: www.johnsoncontrols.com/contact-us
Technical specications
Specication Description
Models
Non-programmable: FCP-NA-701-N, FCP-NA-701-B
Programmable: FCP-PA-701-N, FCP-PA-701-B
Power requirements
20 VAC to 30 VAC, 60 Hz, max. 3 A (3 VA at 24 V nominal)
Output rating
Valve and fan outputs 1 A maximum per each relay channel
(Max. relays ON combination: 3 relays), 20 VAC to 30 VAC
Analog inputs
Remote sensor 10K ohm at 77°F (25°C) NTC sensor
Pipe sensor 10K ohm at 77°F (25°C) NTC sensor
Set back NC/NO dry contact switch
Local temperature sensor type
NTC temperature sensor, accurate to ±1°F (±0.6°C) at 77°F (25°C)
Remote temperature sensor type
NTC temperature sensor, accurate to ±2°F (±1.2°C) at 70°F (21°C)
Wire size
18 AWG (100 ft [30.5 m] maximum) to 24 AWG (36 ft [11 m] maximum)
Temperature adjustment range
Heat mode 45°F to 90°F (7°C to 32°C)
Cool mode 60°F to 95°F (15°C to 35°C)
Accuracy
Local temperature
sensor
±1°F (+/-0.6°C)
Remote temperature
sensor
±2°F (±1.2°C) at 70°F (21°C)
Remote pipe sensor ±5°F (±3.0°C)
Deadband
2°F to 5°F (1°C to 3°C)
Ambient conditions
Operating 14°F to 122°F (-10°C to 50°C); 5% RH to 90% RH, noncondensing
Storage -4°F to 140°F (-20°C to 60°C); 5% RH to 90% RH, noncondensing
Disconnection means
Type 1B
Pollution degree
2
Rated impulse voltage
330 V
Automatic Action
100,000 cycles
Ratings for supply and loading
20 VAC to 30 VAC
Dimensions H x W x D
3.27 in. x 3.94 in. x 0.98 in. (83 mm x 100 mm x 25 mm)
Shipping weight
Product with packing and accessories: 10.1 oz (285 g)
Thermostat only: 4.9 oz (138 g)
Trim plate: 1.2 oz (33 g)
Compliance
ETL/cETL Listed, Mexico NOM
Conforms to UL STD. 60730-1 & 60730-2-9
Certied to CSA STD. E60730-1 & E60730-2-9
Table 8: FCP technical specications
Table 7: Common errors (part 2 of 2)
Error code Description Solution
ER:12 ERROR_PIPE_
SENSOR_LO
Pipe sensor detected a too low temperature.
Verify if the pipe sensor is installed correctly in the pipe.
Contact technical support.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Johnson Controls FCP-NA-701 and is the answer not in the manual?

Johnson Controls FCP-NA-701 Specifications

General IconGeneral
BrandJohnson Controls
ModelFCP-NA-701
CategoryThermostat
LanguageEnglish

Related product manuals