Table 18: TEC3000 Series Networked and Wireless Proportional Fan Coil and Individual Zone Thermostat
Controllers with Dehumidification Capability technical specifications
Specification Description
Backlit display -40.0°F/-40.0°C to 122.0°F/50.0°C in 0.5° increments
Heating control 40.0°F/4.5°C to 90.0°F/32.0°C
Temperature
range
Cooling control 54.0°F/12.0°C to 100.0°F/38.0°C
Temperature ±0.9F°/±0.5C° at 70.0°F/21.0°C typical calibratedAccuracy
Humidity ±5% RH from 20 to 80% RH at 50 to 90°F (10 to 32°C)
Minimum Deadband 2F°/1C° between heating and cooling
Occupancy sensor motion detection
(occupancy sensing models)
Minimum of 94 angular degrees up to a distance of 15 ft (4.6 m); based on a
clear line of sight
Operating 32°F to 122°F (0°C to 50°C); 95% RH maximum, noncondensingAmbient
conditions
Storage -22°F to 122°F (-30°C to 50°C); 95% RH maximum, noncondensing
BACnet
International
BACnet Testing Laboratories
™
(BTL) 135-2001 Listed BACnet Advanced
Application Controller (B-AAC)
UL Listed, File E27734, CCN XAPX, Under UL60730
Networked models: FCC Compliant to CFR 47, Part 15, Subpart B, Class B
United States
Wireless models: Transmission complies with FCC Part 15.247 regulations for
low power unlicensed transmitters; transmitter identification FCC ID: OEJ-
WRZRADIO (ZFR182x), OEJ-ZFRRADIO (ZFR183x)
UL Listed, File E27734, CCN XAPX7, Under E60730
Networked models: Industry Canada, ICES-003
Compliance
Canada
Wireless models: Industry Canada (IC) RSS-210;
Transmitter identification ZFR1810-1: IC ID: 279A-WRZRADIO (ZFR182x), 279A-
ZFRRADIO (ZFR183x)
Europe (for
networked models
only)
CE Mark – Johnson Controls declares that this product is in compliance with the
essential requirements and other relevant provisions of the EMC Directive and
the RoHS Directive.
Australia and New
Zealand
RCM Mark, Australia/NZ Emissions Compliant
Models without
occupancy sensor
0.75 lb (0.34 kg)Shipping Weight
Models with
occupancy sensor
0.77 lb (0.35 kg)
The performance specifications are nominal and conform to acceptable industry standards. For application at conditions
beyond these specifications, consult the local Johnson Controls office. Johnson Controls shall not be liable for damages resulting
from misapplication or misuse of its products.
Repair information
If the TEC3000 Series Thermostat Controller fails to
operate within its specifications, replace the unit. For a
replacement thermostat controller, contact the nearest
Johnson Controls
®
representative.
Product warranty
This product is covered by a limited warranty, details
of which can be found at www.johnsoncontrols.com/
buildingswarranty.
Software terms
Use of the software that is in (or constitutes)
this product, or access to the cloud, or hosted
services applicable to this product, if any, is
subject to applicable end-user license, open-source
software information, and other terms set forth at
www.johnsoncontrols.com/techterms. Your use of this
product constitutes an agreement to such terms.
Patents
Patents: https://jcipat.com
TEC3000 Series Proportional Fan Coil Thermostats Installation Guide 39
To Next Page
Loading...
Need help?
General
