Jonsered GC2128C User Manual

English---10
545186870 Rev. 2 4/30/09
ASSEMBLY
Assembling and dismantling
thetwo--pieceshaft
Assembly:
S Loosen the coupling by turning the knob.
S Align the tab of the attachment (A) with
the arrow on the coupling (B).
N
O
TE: Make sure unit is assembled cor-
rectly as shown in this manual.
Fittin g the J-handle
S Clip the loop handle onto the shaft.
Note that the loop handle must be fitted
between the arrows on the shaft.
S Slide the spacer into the slot in the loop
handle.
S Fit the nut, knob and screw. Do not over-
tighten.
S Attach the J--handle to the loop handle
using the three screws as shown.
S Make a final adjustment of the handle to a
comfortable working position. Tighten the
bolt/knob.
W ARNING: Only grass blades/
grass cutters or trimmer heads/plastic
blades may be used when the
J--handleisfitted.Sawbladesmust
never be used with the J--handle.
S Push the attachment into the coupling until
the attachment snaps into place.
S Before using the unit, tighten the knob se-
curely.
B
A
Dismantling:
S Loosen the coupling by turning the knob
(at least three times).
S Push and hold the button (C). While
securely holding the engine end, pull the
attachment straight out of the coupling.
C
Fitting the harness
Proper harness and handlebar adjust-
ments must be made with the engine com-
pletely stopped before using unit.
WARNING: When using a
brushcutter, it must always be
hooked securely to the harness.
Otherwise, you will be unable to
control the brushcutter safely.
This can result in injury to yourself
or others.
ENGINE

Jonsered GC2128C Specifications

General

Brand	Jonsered
Model	GC2128C
Category	Trimmer
Language	English