– 9 –– 9 –‒ 9 ‒
<When using the sewing machine for the rst time>
Lubricating oil has been taken out at the time of delivery.
Be sure to supply lubricating oil before using the sewing
machine for the rst time.
• Oil used : JUKI GENUINE OIL 18
Do not use oil addition agent since deterio-
ration of lubricating oil or machine trouble
will be caused.
To add oil, remove first the oil inlet cap
indicated as
"OIL". Then, add oil from the oil inlet until the oil surface
reaches the middle of the upper and lower marker lines on
oil gauge
.
<Checking before using the sewing machine>
1) Check oil gauge
and make sure that lubricating oil
level is between the upper and lower two lines. When
lubricating oil level lowers below the lower line, supply
lubricating oil.
2) Make sure that lubricating oil comes out from the
nozzle of oil circulation identication window
when
rotating the sewing machine. When lubricating oil does
not come out, perform “
-3
Inspecting and replac-
ing the oil lter”. (See page 29.)
8. Installing the needle bar thread take-up cover
1. Lubricating oil
Lubrication
. LUBRICATION AND OILING
Install the needle bar thread take-up cover supplied with
the unit on the machine arm with two screws
.
To Next Page
Loading...
Need help?
General
