To Next Page

To Previous Page

CONTENTS

1. SPECIFICATION ............................................................................................................1

2. NAMES OF MAJOR PARTS .......................................................................................... 2

3. INSTALLATION .............................................................................................................. 3

4. LUBRICATION AND DRAINAGE .................................................................................. 6

5. THREADING .................................................................................................................. 8

6. ADJUSTING THE THREAD TENSION ........................................................................ 11

7. REPLACE THE NEEDLE ............................................................................................. 12

8. ADJUSTING THE STITCH LENGTH ........................................................................... 13

9. ADJUSTING THE DIFFERENTIAL FEED RATIO ....................................................... 13

10. REPLACE THE KNIVES .............................................................................................. 14

11. ADJUSTING THE OVEREDGE WIDTH ....................................................................... 15

12. ADJUSTING THE NEEDLE HEIGHT .......................................................................... 15

13. ADJUSTING THE PRESSER FOOT ........................................................................... 16

14. ADJUSTING THE FEED DOG ..................................................................................... 18

15. THE RELATIONSHIP BETWEEN THE NEEDLE AND THE LOOPER ....................... 19

16. ADJUSTING THE AMOUNT OF TRAVEL OF THE DOUBLE CHAINSTITCH LOOP-

ER ................................................................................................................................. 21

17. MAINTENANCE ........................................................................................................... 22

18. DIMENSIONS USE TO ADJUSTING THE LOOPER AND THE NEEDLE GUARD

..... 23

19. DIMENSIONS RELATED TO THE POSITION OF THE THREAD TAKE-UP AND

THE LOOPER THREAD CAM STANDARD ADJUSTMENT .................................... 24

20. TABLE DRAWING ....................................................................................................... 26

TRIAL MODE − a valid license will remove this message. See the keywords property of this PDF for more information.

JUKI MO-6814S User Manual

Other manuals for JUKI MO-6814S