●
Front open type
This type is suited for free-motion
quilting. The needle entry point is
easily observed since the front sec-
tion is open.
Quilting foot
CAUTION:
Turn OFF the power switch when replacing the presser foot.
This quilting foot is convenient for free motion quilting, quilting along with the pattern, free-hand embroidery, etc.
* Do not run the sewing machine idle when the quilting foot is kept at its upper position.
1
Turn o power. Install the quilting foot. Put
the plate on the needle clamp screw, insert
the installing portion into the presser bar, and
securely tighten the screw in the presser foot.
2
Position Feed Dog in lower position.
3
Position stitch length adjusting dial ”0”. Rotate
presser foot pressure regulator until blue bar
in pressure indication window is at top.
4
Lower the foot and start sewing.
1/5 inch (5.0 mm)
1/8 inch (3.2 mm)
1/4 inch (6.5 mm)
1/8 inch (3.2 mm)
●
1/4 inch = 6.5 mm type
This type is suited as a guide for
sewing stitches at regular intervals.
Plate
Screw in the presser foot
Needle clamp screw
Presser
bar
27
To Next Page
Loading...
Need help?
General
