Save light scene
i This function is only available in operating modes 5 to 8.
Light scene button of the transmitter has been taught-in.
o Set the required lighting situation.
o Press the required light scene button for at least 3 s.
Firstly, the old light scene button is opened, do not release the button. After about 3 s the
new light scene is saved and activated.
i If, when a light scene is saved, the shutter is not in the end position or on the way there,
this shutter is not integrated into the light scene.
6 Appendix
Remove empty batteries immediately and dispose of in an environmentally friendly
manner. Do not throw batteries into household waste. Consult your local authorities
about environmentally friendly disposal. According to statutory provisions, the end
consumer is obligated to return used batteries.
6.1 Technical data
Rated voltage DC 3 V
Battery type 1×lithium CR 2032
Cable length approx. 290 mm
carrier frequency 433.42 MHz (ASK)
Transmitting range in free field typical 100 m
Protection rating IP 20
Ambient temperature -20 ... +55 °C
Relative humidity max. 65 % (No moisture condensation)
Dimensions L×W×H 45×40×10 mm
6.2 Troubleshooting
Receiver does not respond, or only sometimes.
Battery in the transmitter is empty.
Replace the battery (see chapter "Replacing the battery").
Radio range exceeded. Structural conditions reduce the range.
Check the antenna routing. Laying the antenna stretched out increases the range.
Use a radio repeater.
Incorrect switch position or incorrect operating mode.
Check the position of the microswitches.
10/11
32535013
J:0082535013
13.08.2010
Radio Management
Radio multifunction transmitter
To Next Page
Loading...
Need help?
General
