To Next Page

To Previous Page

2. Set the IP addresses of the built-in Ethernet ports. For example:

■ On a J2300 router:

root# set interfaces fe-0/0/0 unit 0 family inet address 192.168.1.1/24

root# set interfaces fe-0/0/1 unit 0 family inet address 192.168.2.1/24

■ On a J4350 or J6350 router:

root# set interfaces ge-0/0/0 unit 0 family inet address 192.168.1.1/24

root# set interfaces ge-0/0/1 unit 0 family inet address 192.168.2.1/24

root# set interfaces ge-0/0/2 unit 0 family inet address 192.168.3.1/24

root# set interfaces ge-0/0/3 unit 0 family inet address 192.168.4.1/24

The unit number is the logical interface number. IP addresses are configured on

the logical interface. Setting the protocol family to inet specifies the routing table

of IPv4 addresses.

3. Set a default route (default gateway) for IPv4 packets. For example:

root# set routing-options static route 192.168.1.254/24 next-hop 10.1.1.50

4. Configure one or more static routes:

root# set routing-options static route destination-prefix next-hop address

5. Set the hostname. For example:

root# set system host-name Chicago

6. Save your configuration settings and activate them on the Services Router:

root# commit

For complete instructions, see the J-series Services Router Basic LAN and WAN Access

Configuration Guide.

J-Web Basics

The task bar at the top of the J-Web interface identifies the main J-Web functions.

You access specific tasks on the left.

■

Monitor—Output from common show commands

■ Configuration—Quick Configuration wizards and a graphical version of the CLI

■ Diagnose—Ping, traceroute, and packet capture

■ Manage—Configuration file management and licenses

■ Events—System log messages

■ Alarms—Active alarms

J-Web Basics ■ 15

J-Web Basics

Juniper J2300 Quick Start Quide

Other manuals for Juniper J2300