Available with remote control models RM-C255, RM-253 and RM-C252 only.
The remote control is programmed with DVD codes for power on, power off, play, stop,
fast-forward, rewind, previous chapter, next chapter, tray open/close, and still/pause operation.
1) Find the DVD player brand from the list of codes shown below.
2) Slide the first 2-way selector switch to “TV” and the other 2-way selector switch to “DVD”.
3) Press and hold down the D
ISPLAY button.
4) With the D
ISPLAY button held down, enter the first code number listed with the 10 key pad.
5) Release the D
ISPLAY button.
6) Confirm the operation of the DVD player.
• If your DVD player does not respond to the first code, try the others listed. If it does not
respond to any code, try the Search Codes Function, on page 51.
• After you program your remote, some DVD buttons may not work properly. If some buttons do
not work properly, use the remote control which came with your DVD player.
To Next Page
Loading...
Need help?
General