Caution:
Be careful not to pinch your fingers in the moving parts.
The Max tilt angle is down 12° and up 12°, please make sure the setup location is stable, to prevent the monitor falling down.
Place the monitor on a mat to avoid scratching the table surface.
6
Installation
Do not rest your arm on the monitor or lean against the monitor.
Do not touch the LCD panel when installing the monitor.
Be sure to install the monitor securely to prevent the monitor from falling over, which may cause damage to the monitor or injury.
The monitor package provides a U shape rotatable desktop stand to be installed.
Using the monitor on U-stand
12° 12°
Fix 2 screws to the center screw holes of left and right side.
Fix the other 2 screws to the downside screw holes. Adjust monitor angle of ±12° by the downside screws.
Slide the monitor into the top mouth of U shape stand.
To Next Page
Loading...
Need help?
General
