14
Necessary Settings before Use
Charging the Battery Pack
1
Close the LCD monitor to turn off the
camera.
2
Attach the battery pack.
Slide the battery pack down until it locks
in place.
Bottom of the Camera
BATT.
3
Connect the AC adapter.
•
You can also connect the AC adapter using
the Everio dock connector.* ( pg. 9)
* GZ-MG330 model does not include the
Everio dock.
•
The access/charge lamp blinks to indicate
charging has started.
•
When the lamp goes out, charging is
fi nished. Unplug the AC adapter from the
AC outlet and disconnect the AC adapter
from the camera
L
To detach the battery pack
Slide and hold BATT. ( step 2), then
remove the battery pack.
L
To check the remaining battery power
See page 15.
NOTES
•
You can also use the camera with just the
AC adapter.
•
Please do not pull or bend the AC adapter
plug and cable. This may damage the AC
adapter.
Date/Time Setting
1
Open the LCD monitor to turn on the
camera.
2
When [SET DATE/TIME!] appears,
select [YES] within 10 seconds.
SET DATE/TIME!
YES
NO
If you do not select within 10 seconds, the
screen disappears. In such case, press
the POWER button and turn the camera
on again.
3
Set the date and time.
DATE TIME
JAN 31
11
AM
07
2007
Repeat this step to input the month, day,
year, hour and minute.
L
To change the date and time
1) Touch the MENU button.
2) Select [BASIC SETTINGS], and then
[CLOCK ADJUST].
3) Set the date and time.
L
To return to the previous screen
Select
@
.
L
To quit the screen
Touch the MENU button.
DC Jack
AC Adapter
To AC Outlet
(110V to 240V)
To Next Page
Loading...
Need help?
General