35
ENGLISH
Warning Indications
Indication Meaning/Action
(Battery indicator)
•
Displays the remaining battery power. –
•
As the battery power comes close to nil, the battery
indicator blinks. When the battery power is exhausted,
power turns off automatically.
–
SET DATE/TIME!
•
Appears when the date/time is not set.
•
The built-in clock’s rechargeable lithium battery is
discharged, so the previously set date/time is erased.
Connect the camera to an AC outlet using the AC adapter
for over 24 hours to charge the clock’s lithium battery. Then
set the date/time.
14
14
CHECK LENS COVER
•
Appears for 5 seconds after power is turned on in recording
mode if the lens cover is closed or when it is dark.
–
HDD ERROR!
MEMORY CARD ERROR!
•
Perform clean up to restore the capacity of the recording media.
•
Turn off the camera. Remove the microSD card and insert it
again. Turn on the camera after inserting the microSD card.
If the error message appears again, replace the card with
one that is certifi ed to operate correctly.
•
It is also recommended to run check disc regularly on the
PC, providing that there is no data on the hard disk of the
camera.
–
–
–
VIDEO MANAGEMENT
FILE IS BROKEN. TO
RECORD/PLAYBACK
VIDEO, RECOVERY IS
REQUIRED. RECOVER?
•
The video management fi le is broken. Recovery is required
to record or play back video fi les. Select [YES], then touch
the OK button to recover the video management fi le.
–
CAN NOT READ EVENT
INFORMATION
•
Appears when the event information cannot be read.
Register the fi le to an event.
–
RECORDING FAILURE
•
The writing speed of recording medium is slow, or the
recording medium is corrupted. Use a microSD card that is
guaranteed to operate correctly.
•
The hard disk was subjected to vibrations or jolts. Be careful
not to subject the hard disk to vibrations or jolts.
•
Appears when the recording medium is full and recording
is not possible. Delete unnecessary fi les, or replace the
microSD card.
–
–
20
POWER IS OFF,
OR USB DEVICE IS
UNSUPPORTED
•
Appears when an incompatible USB device is connected to
the camera.
•
Appears when a DVD burner that is switched off is
connected. If you want to use the DVD burner, switch the
power on.
–
–
DROP DETECTION
WORKED AND THE
POWER IS TURNED OFF
•
To turn on the camera again, close the LCD monitor and
open it again.
–
High Exhausted
To Next Page
Loading...
Need help?
General