Introduction
6
You can operate your TV using the remote control
of this system.
1 Slide the remote con-
trol mode selector to
[TV].
2 Hold down [F TV].
• Hold down [F TV] until you finish step 4.
3 Press [ENTER] and release.
4 Press the number buttons to enter
the manufacturer code.
Examples:
For a Hitachi TV: Press [1], then [0].
For a Toshiba TV: Press [0], then [8].
When the manufacturer of your TV has two or
more codes, select the manufacturer codes in turn
and find the one that operates the TV and the
remote control properly.
5 Release [F TV].
NOTE
• Manufacturer codes are subject to change with-
out notice. You may not be able to operate the
TV produced by the manufacturer.
• After replacing the batteries of the remote con-
trol, set the manufacturer code again.
Operate the remote control by pointing it at the TV.
.
Operating a TV using the
remote control
Remote control
mode selector
Number buttons/
TV RETURN/
100+
Setting the manufacturer code
Manufacturer Code Manufacturer Code
JVC 01 Samsung 12
Hitachi 10 Sanyo 13
Magnavox 02 Sharp 06
Mitsubishi 03 Sony 07
Panasonic 04,
11 Toshiba 08
Philips 14 Zenith 09
RCA 05
Remote
control button
Usage
[
F TV ]
Turns on/off the TV.
[TV/VIDEO]
Changes between the TV and
video input.
[TV CH +/
–
] Changes channels.
[TV VOL +/
–
] Adjusts volume.
Number but-
tons (1-9, 0,
100+)
Slide the
remote control
mode selector
to [TV] in
advance.
Selects the
channels.
[TV RETURN]
Changes
between the
previously
selected chan-
nel and the cur-
rent channel.
Using the remote control for the TV
operation
EX-A3[J_C].book Page 6 Wednesday, December 27, 2006 3:53 PM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
