7
Preparation
Setting up the AM loop antenna
Connecting the AM loop antenna
Turn the AM loop antenna to find the best position
for radio reception.
NOTE
• Make sure that the antenna conductors do not
touch any other terminals. This could cause poor
reception.
When radio reception with the supplied FM
antenna is poor, or when using a communal
antenna
When using an antenna other than those supplied
with this system, refer to the operation manuals for
the antenna and converter for details of connec-
tion.
When positioning the antennas, find the best posi-
tion for reception while listening to an actual radio
program (refer to “Listening to radio broadcasts”
on page 19).
Connecting the antennas
AM loop antenna (supplied)
If insulation covers the tips of the
antenna cable, twist and pull off
the insulation.
Main unit (rear view)
FM antenna (supplied)
Main unit (rear view)
FM antenna
Stretch out the FM antenna
to the best position for
radio reception.
Main unit (rear view)
Antenna cable
(not supplied)
Outdoor FM
antenna
(not supplied)
Converter (not sup-
plied: compatible
with 300
C
/75
C
)
Coaxial cable
(not supplied)
Depending on the radio reception
conditions, an FM feeder antenna
(not supplied: compatible with
300 C) can be used. In this case,
a converter (not supplied) is
required.
or
Communal
antenna terminal
Preparation
Do not turn on the power until you complete the connection.
EX-A3[J_C].book Page 7 Wednesday, December 27, 2006 3:53 PM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
