11
Connecting up Connection
CAUTION
Connect the main unit directly with a TV (or a
monitor) without routing through a VCR.
Otherwise it may cause picture distortion while
playing.
Also, when connecting the main unit to a TV with
a VCR built in, there may be picture distortion
while playing.
You can enjoy pictures of better quality using the
following cord instead of the supplied video cord.
Connecting by using the S-Video cord
Connecting by using the component video
cord
You can enjoy better quality pictures than when
using the S-Video cord.
CAUTION
Use one of either the S-Video cord or the
component video cord. If both cords are used,
pictures may not be played properly.
NOTE
• In order to enjoy pictures with Progressive mode
(page 26), the TV is required to have Progressive
video input.
• If the component video input jacks of your TV are
BNC type, use a plug adapter (not supplied) to
convert the plugs.
• Connect the power cord after all other
connections are complete.
• The standby lamp (on the front panel) will be lit.
Connecting with TV
VIDEO
S-VIDEO
COMPONENT
YPB PR
VIDEO OUT
TV
Supplied composite video cord
Main unit
Main unit
Connecting directly
TV (or
monitor)
VIDEO
S-VIDEO
COMPONENT
YPB PR
VIDEO OUT
TV
Main unit
S-Video cord (not
supplied)
Connecting the power cord
VIDEO
S-VIDEO
COMPONENT
YPB PR
VIDEO OUT
Component video cord
(not supplied)
Main unit
Blue
Red
Green
AC outlet
Supplied power cord
Main unit
Getting started
EX-D1[J].book Page 11 Wednesday, March 2, 2005 9:53 PM
To Next Page
Loading...
Need help?
General
