EN 27
A
B
There are two basic types of connections. When making
the connections, refer also to your VCR and TV
instruction manuals.
Connection To A VCR [A]
(Editing, Dubbing and Playback)
NOTE:
Use the provided Audio and Video cables.
CONNECT CAMCORDER TO VCR
1
As shown in the illustration at left, connect the
Audio and Video cables between the AUDIO and
VIDEO connectors on the camcorder and those on
the VCR.
SUPPLY POWER
2
Turn on the camcorder, the VCR and the TV.
SELECT MODE
3
Set the VCR to its AUX input mode, and set the TV
to its VIDEO mode.
Connection To A TV With A/V Input
Connectors [B] (Playback ONLY)
NOTE:
Use the provided Audio and Video cables.
CONNECT CAMCORDER TO TV
1
As shown in the illustration at left, connect the
Audio and Video cables between the AUDIO and
VIDEO connectors on the camcorder and those on
the TV.
SELECT MODE
2
Set the TV to its VIDEO or AV mode (as specified in
its instructions).
NOTES:
●
It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the battery
pack.
●
To monitor the picture and sound from the camcorder
without inserting a tape, set the camcorder’s Power
switch to “CAMERA”, then set your TV to the appropri-
ate input mode.
●
If you have a TV or speakers that are not specially
shielded, do not place the speakers adjacent to the TV
as interference will occur in the camcorder playback
picture.
PLAYBACK
Basic Connections
When
connecting the
cables, open
the jack cover.
To AUDIO and
VIDEO connectors
To AUDIO and
VIDEO IN
connectors
Audio and Video
cables (provided)
If your TV/VCR
has the SCART
connector, use
the provided
cable adapter.
VCR
Downloaded from: https://www.usersmanualguide.com/
To Next Page
Loading...
Need help?
General
