EN 15
MasterPage: Start_Right
Recording & Playback
ENGLISH
During recording, a time code is recorded on
the tape. This code is to confirm the location of
the recorded scene on the tape during
playback.
1, 3, & 4, time code begins counting from
“00:00:00” (minute:second:frame).
2, time code continues from the last time
code number.
If during recording a blank portion is left
partway through the tape, the time code is
interrupted. When recording is resumed, the
time code starts counting up again from
“00:00:00”.
To prevent this, perform “Recording from the
middle of a tape”
(墌 15) in the following cases;
● When shooting again after playing back a
recorded tape.
● When power shuts off during shooting.
● When a tape is removed and re-inserted during
shooting.
● When shooting using a partially recorded tape.
● When shooting again after shooting a scene
then opening/closing the cassette holder cover.
Notes:
● The time code cannot be reset.
● During fast-forwarding and rewinding, the time
code indication does not move smoothly.
● The time code is displayed only when “TIME
CODE” is set to “ON” (墌 20).
Recording from the middle of a tape
Playback a tape or use Blank Search
(墌 17) to find the spot at which you want to
start recording, then engage the Still
Playback mode (墌 16).
Set the Power Switch to “REC” (墌 9), then
start recording.
Auto/Manual Mode
Time Code
Press AUTO button repeatedly to switch to
auto/manual recording mode. When manual
mode is selected, the indicator “M” appears
on the LCD monitor.
Auto Mode : A
You can record using no special effects or
manual adjustments.
Manual Mode : M
Recording is possible by setting various
functions manually.
M
12:34:24
1
2 3 4
Minutes
Seconds
Frames
(25 frames
1 second)
Recording Portion
Blank Portion
Recording Start Point
recorded
tape
Display
1
2
GR-D850AA_EN.book Page 15 Thursday, October 18, 2007 5:26 PM
To Next Page
Loading...
Need help?
General
