EN
7
Automatic Demonstration takes place when “DEMO
MODE” is set to “ON” (factory-preset).
䡲 Automatic Demonstration starts when there is no operation for
about 3 minutes after the Power Switch is set to “ ” or “ ” and
no cassette is in the camcorder.
䡲 Performing any operation during the demonstration stops the
demonstration temporarily. If no operation is performed for more
than 3 minutes after that, the demonstration will resume.
䡲 “DEMO MODE” remains “ON” even if the camcorder power is
turned off.
䡲 To cancel Automatic Demonstration:
1. Set the Power Switch to “ ” while pressing down the Lock
Button located on the switch and press the MENU wheel in.
The Menu Screen appears.
2. Rotate the MENU wheel to select “ SYSTEM” and press it.
The SYSTEM Menu appears.
3. Rotate the MENU wheel to select “DEMO MODE” and press
it. The Sub Menu appears.
4. Rotate the MENU wheel to select “OFF” and press it.
5. Rotate the MENU wheel to select “ RETURN”, and press it
twice. The normal screen appears.
MENU Wheel
Sub Menu
AUTOMATIC DEMONSTRATION
To Next Page
Loading...
Need help?
General
