JVC GR-DVA10 User Manual

IOTE CONTROL UNIT (cont.)
Audio Dubbing
‘The audio track can be customized only when recorded in
the 12-bit mode (CF pg. 23).
NOTES:
© Audio Dubbing is not possible on a tape recorded in
16-bit audio, on a tape recorded in the LP mode or on a
blank portion of a tape.
© To perform Audio Dubbing while watching on the
television, make connections (pg. 34).
Play back the tape to locate the point where editing
will start, then press PAUSE (31).
While holding A.DUB ($) on the remete control,
press PAUSE (IN). “INS” appears.
Press PLAY (b), then begin “narrating”
Speak into the microphone.
To pause dubbing, press PAUSE
To end Audio Dubbing, press PAUSE (IW), then STOP
.
To hear the dubbed sound during playback...
set “12BIT MODE” to “SOUND 2” or “MIX” in the
Menu Screen (& pg. 32, 33).
NOTES:
© Sound is not heard from the speaker during Audio
Dubbing.
© When editing onto a tape that was recorded at 12-bit,
the old and new soundtracks are recorded separately.
‘©1f you dub onto a blank space on the tape, the sound
may be disrupted. Make sure you only edit recorded
areas.
(© 1f feedback or howling occurs during TV playback, move
the camcorder’s microphone away from the TV, or turn
down the TV's volume.
(i you change from 12-bit to 16-bit in mid-recordling and
then use the tape for Audio Dubbing, it is not effective
from the point where 16-bit recording began.
‘© During Audio Dubbing, when the tape moves to scenes
recorded in the LP mode, scenes recorded in 16-bit
audio or a blank portion, Audio Dubbing stops
( pg. 61).
no 1
You can record a new scene into a previously recorded
tape, replacing a section of the original recording with
minimal picture distortion at the in and outpoints. The
original audio remains unchanged.
NOTES:
Before performing the following steps, make sure that
“TIME CODE?” is set to “ON” in the Menu Screen
(CF pg. 32).
‘© Insert Editing is not possible on a tape recorded in the LP
‘mode or on a blank portion of a tape.
© To perform Insert Editing while watching in the
television, make connections (CF pg. 34).
WA 2y back the tape, locate the Eci-Out point and
press PAUSE (HH). Confirm the time code at this point
(CF pg. 33).
Press REW (-¢4) until the Edit-In point is located, then
press PAUSE (11).
fees and hold INSERT (©) on the remote control,
then press PAUSE (II). “INO” and the Time Code
(min.-sec.) appear and the camcorder enters Insert-
Pause mode.
Pi Press START/STOP to begin edting
‘Confirm the insert at the time code you checked in
step 1.
* To pause editing, press START/STOP. Press it again
to resume editin
fag To end inser Echtng, press START/STOP, then STOP
fo (wm)
NOTES:
© Program AE with special effects (7 pg. 28) can be used
to spice up the scenes being edited during Insert Editing.
‘© During Insert Editing, the date and time information
changes.
@ If you perform insert Editing onto a blank space on the
tape, the audio and video may be disrupted, Make sure
you only edit recorded areas.
‘© During Insert Editing, when the tape moves to scenes
recorded in the LP mode or a blank portion, Insert Edting
stops (F pg. 61).

JVC GR-DVA10 Specifications

General

Brand	JVC
Model	GR-DVA10
Category	Camcorder
Language	English