EN37
1
I
S
P
D
F
R
N
L
R
E
O
E
D
I
O
L
R
T
E
D
T
E
M
D
U
X
E
E
T
A
S
R
C
E
T
C
N
S
T
H
M
O
E
W
NU
P
L
A
Y
O
F
F
001 F 002 S
003 S
005 F
004 F
EXIT
006 F
<
PROTECT
>
001 F 002 S
003 S
005 F
004 F
EXIT
006 F
<
PROTECT
>
Display
Power Switch
MENU/BRIGHT Wheel
Lock Button
If Protection is
removed
PROTECT Index
Screen
Normal playback
Padlock mark
Normal playback
Protecting Images
The Protect mode helps prevent the accidental erasure of
images. When a padlock mark is displayed next to the
Picture Quality Mode indication, that image cannot be
deleted.
1
Set the VIDEO/DSC Switch to “ ”, then set the
Power Switch to “ ” while pressing down the
Lock Button.
•A stored image is displayed.
2
Press MENU/BRIGHT. The Menu Screen appears.
Rotate it to select “ ” and press it. “DSC MENU”
appears.
3
Rotate MENU/BRIGHT to select “PROTECT” and
press it. The PROTECT Index Screen appears.
TO PROTECT AN IMAGE
Before doing the following, perform steps 1 through 3
above.
4
Rotate MENU/BRIGHT to move the green frame to
the desired image and press it. A “ ” padlock mark
appears on the selected image.
Repeat this procedure for all images you do not wish
to delete by accident.
5
Rotate MENU/BRIGHT upward to select “EXIT” and
press it. The normal playback screen appears.
NOTE:
When the memory is initialised or corrupted, even
protected images are deleted. If you do not want to lose
important images, transfer them to a PC and save them.
TO REMOVE PROTECTION
Before doing the following, perform steps 1 through 3
above.
4
Rotate MENU/BRIGHT to move the green frame to
the desired image and press it. The “ ” padlock
mark located above the image disappears and the
image is no longer protected.
Repeat this procedure for all images from which you
wish to remove protection.
5
Rotate MENU/BRIGHT upward to select “EXIT” and
press it. The normal playback screen appears.
Menu Screen
VIDEO/DSC Switch
(Open the LCD monitor
to access this switch.)
To Next Page
Loading...
Need help?
General
