EN11
GETTING STARTED
Grip Adjustment
1
Separate the Velcro strip.
2
Pass your right hand through the loop and grasp the
grip.
3
Adjust so that your thumb and fingers can easily
operate the Recording Start/Stop Button and the
Power Zoom Lever. Refasten the Velcro strip.
Power Zoom Lever
CAUTION:
When using a tripod, be sure to open and extend
its legs fully to stabilise the camcorder. To
prevent damage to the unit caused by falling
over, do not use a small-sized tripod.
Dioptre
Adjustment
Control
Shoulder Strap Attachment
1
Following the illustration, thread the strap through the
eyelet 1, then fold it back and thread it through the
buckle 2. Repeat the procedure to attach the other
end of the strap to the other eyelet 3, making sure
the strap is not twisted.
2
Adjust as shown in the illustration 4.
Tripod Mounting
1
Align the screw and camera direction stud on the
tripod with the camera’s mounting socket and stud
hole. Then tighten the screw.
Viewfinder Adjustment
1
Set the Power Switch to “ ” or “ ”.
The power lamp comes on and the camcorder is
turned on.
2
Slide the Dioptre Adjustment Control until the
indications in the viewfinder are clearly focused.
3
2
4
1
Recording
Start/Stop Button
Power Switch
To Next Page
Loading...
Need help?
General
