38 EN
5m
30°
30°
USING THE REMOTE CONTROL UNIT
Installing The Battery
The Full-Function Remote Control Unit can operate
this camcorder from a distance as well as the basic
operations (Playback, Stop, Pause, Fast-Forward and
Rewind) of your VCR. It also makes additional
playback functions possible.
The remote control uses one lithium battery
(CR2025).
1
Pull out the battery holder while pressing the
knob as shown.
2
Insert the battery in the holder, and be sure to
have the “+” mark visible.
3
Slide the holder back in until you hear a click.
•Read the caution concerning lithium batteries
(Z pg. 2).
When using the remote control, be sure to point it
at the remote sensor. The illustration shows the
approximate transmitted beam effective area for
indoor use.
The transmitted beam may not be effective or may
cause incorrect operation outdoors or when the
remote sensor is directly exposed to sunlight or
powerful lighting.
Transmitted beam
effective area
1
1
3
2
Knob
Remote sensor
To Next Page
Loading...
Need help?
General
