8 EN
Master Page: Left
GR-DVX707EG_02-08.fmPage 8
Automatic Demonstration
Automatic Demonstration takes place when “DEMO
MODE” is set to “ON” (factory-preset).
䡲 Automatic Demonstration starts when there is no
operation for about 3 minutes after the Power Switch is
set to “A” or “M” and no cassette is in the camcorder.
䡲 Performing any operation during the demonstration
stops the demonstration temporarily. If no operation is
performed for more than 3 minute after that, the
demonstration will resume.
䡲 “DEMO MODE” remains “ON” even if the camcorder
power is turned off.
䡲 To cancel Automatic Demonstration:
1) Set the Power Switch to “M” while pressing down the
Lock Button located on the switch.
2) Open the LCD monitor fully, or pull out the viewfinder
fully.
3) Press the MENU Wheel in. The Menu Screen appears.
4) Rotate the MENU Wheel to select “s SYSTEM”, and
press it. The SYSTEM Menu appears.
5) Rotate the MENU Wheel to select “DEMO MODE”,
and press it. The Sub Menu appears.
6) Rotate the MENU Wheel to select “OFF”, and press it.
7) Rotate the MENU Wheel to select “BRETURN”, and
press it twice. The normal screen appears.
NOTE:
Detach the lens cap to see the actual changes of the
Automatic Demonstration activated on the LCD monitor
or viewfinder.
MOD EDEMO
ON
OF F
OFF
P
L
A
Y
A
M
Power Switch
Lock Button
MENU Wheel
Sub Menu
GR-DVX707/
507 only
GR-DVX707EG_02-08.fm Page 8 Tuesday, February 5, 2002 1:43 PM
To Next Page
Loading...
Need help?
General
