EN105
Indications Function
Displays the battery remaining power.
Remaining power level: high
Remaining power level: exhausted
As the battery power comes close to nil, the battery indicator blinks.
When the battery power is exhausted, power turns off automatically.
Appears when no tape is loaded, or when the erase protection tab is set to
“SAVE”. (Z pg. 12)
Appears if dirt is detected on the heads during recording. (Z pg. 108)
Appears if condensation occurs. When this indication is displayed, the camcorder
turns off automatically.
Appears for approx. 10 seconds when the Power Switch is set to “ ” or “5S”
when a tape is not loaded.
Appears when the tape ends during recording or playback. (Z pg. 19)
● Appears when the date/time is not set. (Z pg. 11)
● Appears when the clock (lithium) battery is discharged and the
previously set date/time is erased. (Z pg. 11)
Appears when Audio Dubbing is unavailable. (Z pg. 90)
Appears when the MultiMediaCard’s memory is full and shooting is not possible.
Displayed for approx. 10 seconds when the Power Switch is set to “ ” or
“ ” when a MultiMediaCard is not loaded.
Appears when there is a problem with a MultiMediaCard and its memory is
corrupt. Initialize the MultiMediaCard. (Z pg. 91)
Appears when the Power Switch set to “ ” when there are no images
stored in the MultiMediaCard.
The error indications (E01 — E06) show what type of malfunction has occured.
When an error indication appears, the camcorder turns off automatically. Remove
the power supply (battery, etc.) and wait a few minutes for the indication to clear.
When it does, you can resume using the camcorder. If the indication remains,
consult your nearest JVC dealer. (Z pg. 97)
Warning Indications
TAPE!
TAPE END
SET DATE/TIME!
E01 — E06
ERROR!
REFER MANUAL
NO STORED
IMAGE
PLEASE
INITIALIZE
MEMORY CARD!
MEMORY IS FULL
To Next Page
Loading...
Need help?
General
