70 EN
Master Page: Left
GR-DVX707EG_37-79.fm Page 70
The audio track can be customised only when
recorded in the 12-bit and SP modes. (墌 pg. 44)
1 Play back the tape to locate the point where
editing will start, then press PAUSE (9).
2 While holding A.
DUB (D) on the
remote control, press
PAUSE (9). The
“9D” indicator
appears.
3 Press PLAY (U), then
begin “narrating”.
Speak into the
microphone.
● To pause dubbing, press PAUSE (9).
4 To end Audio Dubbing, press PAUSE (9), then
STOP (8).
To hear the dubbed sound during playback…
Set “12BIT MODE” to “SOUND 2” or “MIX”.
(墌 pg. 38, 51)
NOTES:
● Sound is not heard from the speaker during Audio
Dubbing. To hear sound, connect optional
headphones to the headphone connector.
(GR-DVX707 only)
● When editing onto a tape that was recorded at
12-bit, the old and new soundtracks are recorded
separately.
● If you dub onto a blank space on the tape, the
sound may be disrupted. Make sure you only edit
recorded areas.
● If feedback or howling occurs during TV playback,
move the camcorder’s microphone away from the
TV, or turn down the TV’s volume.
● If you change from 12-bit to 16-bit in mid-
recording and then use the tape for Audio
Dubbing, it is not effective from the point where
16-bit recording began.
● During Audio Dubbing, when the tape moves to
scenes recorded in the LP mode, scenes recorded
in 16-bit audio or a blank portion, Audio Dubbing
stops.
● To perform Audio Dubbing while watching on the
television, make connections. (墌 pg. 24, 25)
Audio Dubbing
PAUSE
PLAY
A.DUB
STOP
Remote sensor
Headphone connector
(GR-DVX707 only)
Speaker
Stereo microphone
Open the
connector cover.
9
D
MIC
GR-DVX707 only
USING THE REMOTE CONTROL UNIT (cont.)
GR-DVX707EG_37-79.fm Page 70 Thursday, January 31, 2002 12:19 PM
To Next Page
Loading...
Need help?
General
