60 EN Troubleshooting
The camera is a microcomputer-controlled
device. External noise and interference (from a
TV, a radio, etc.) might prevent it from
functioning properly.
● To solve the problem, first follow the
instructions below.
● If the problem is not solved, reset the camera.
(墌 right column)
● If the problem persists, please consult your
nearest JVC dealer.
To reset the camera
1) Press RESET using a piece of wire or other
pointed instrument. The power is turned off
once and turned on again automatically.
2) If nothing happens, set the power switch to
OFF and remove the power supply (battery
pack or AC adapter) from the camera, then
reattach it.
3) Execute [PRESET] from the menu. The
camera returns to its factory-preset.
(墌 pg. 55)
RESET
Trouble Action
墌
Power
No power is supplied.
● Connect the AC adapter securely.
● Detach the battery pack once again and re-attach it firmly.
● Replace the dead battery with a fully charged one.
14
14
–
No display appears.
● When using the AC adapter, the camera enters the sleep mode,
the access lamp lights, and the LCD monitor turns off.
To cancel the sleep mode, perform any operation such as
zooming.
–
The power was turned
off accidentally.
● The drop detection function operated.
Set the power switch to OFF, and turn the power on again. To
turn off the drop detection function, set [DROP DETECTION] to
[OFF].
55
M6E3PAL.book Page 60 Monday, May 29, 2006 8:50 AM
To Next Page
Loading...
Need help?
General
