Press SET –/+ on the Remote to
select a channel number you
want to add or delete.
To add channels
Press ENTER until “ADD” appears on the screen to set to
add the unmemorized channel.
To delete channels
Press ENTER until “DELETE” appears on the screen to set
to delete the channel from memory.
Repeat to to add or delete other channel.
Press MENU three times to return to normal screen.
Setting channels manually
– Manual Channel Set
You can add the channels you want or delete the channels
you do not want manually.
CH SETUP
TV CATV
AUTO CH MEMORY
ADD/DELETE
CH 012
á
+
/
Ð
/0
Ð
9/ENTER/MENU
ñ
ADD
1
2
Add or Delete desired
channels
3
Access ADD/DELETE Mode
Press SET –/+ to select “ADD/
DELETE”, then press ENTER.
Access Menu screen, then
CH Setup screen
Press MENU on the Remote.
Press SET –/+ to select “CH
SETUP”, then press ENTER.
1
2
3
1 2
NOTE: You can’t select “CH SETUP” if you set the channel to “L”.
á
+/Ð/ENTER/MENU
ñ
MENU
TIMER REC SET
AUTO REPEAT
ON OFF
ON OFF
SAP
CH SETUP
SYSTEM SETUP
Make sure the window side is up, the rear
label side is facing you and the arrow on
the front of the cassette is pointing
towards the VCR.
Basic Playback
Load a cassette
Playback
OR Press STOP/EJECT (■/
)
on the VCR.
1
2
• Do not apply too much pressure when
inserting.
• The VCR turns on, and the counter is
reset, automatically.
• If the cassette’s record safety tab has been removed, playback
begins automatically.
• If you press any operation buttons while the cassette is not
loaded, “
“ will flash on the screen for 4 seconds.
Start playback
Press PLAY ( ).
During playback
Stop playback
Press STOP (
) on the
Remote.
Pause playback and view still picture
Press PAUSE.
• Press PLAY ( ) to resume
normal playback.
Pause and Frame-by-Frame playback
Press PAUSE to pause, then
press PAUSE repeatedly.
Press PLAY (
) to resume
normal playback.
– Initial Settings –
4F90401AE Cov-07 11/25/02, 03:02 PM7
To Next Page
Loading...
Need help?
General
