KD-AVX11
Installation/Connection Manual
LVT1657-006A
[A]
0107MNMMDWJEIN
EN
©2007 Victor Company of Japan, Limited
This unit is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If your vehicle does
not have this system, a voltage inverter is required, which can be purchased at JVC car audio dealers.
WARNINGS
• DO NOT install any unit and wire any cable in locations where;
– it may obstruct the steering wheel and gearshift lever operations, as this may result in a traffic accident.
– it may obstruct the operation of safety devices such as air bags, as this may result in a fatal accident.
– it may obstruct visibility.
• DO NOT operate any unit while manipulating the steering wheel, as this may result in a traffic accident.
• The driver must not watch the monitor while driving.
If the driver watches the monitor while driving, it may lead to carelessness and cause an accident.
• If you need to operate the unit while driving, be sure to look around carefully.
• If the parking brake is not engaged, “Parking Brake” appears on the monitor, and no playback picture
will be shown.
– This warning appears only when the parking brake wire is connected to the parking brake system built
in the car.
J
Rubber cushion
F
Crimp connectors
G
Washer (ø5)
H
Lock nut (M5)
I
Mounting bolt—
M5 x 20 mm
C
Sleeve
E
Power cord
Parts list for installation and connection
The following parts are provided for this unit. After checking them, please set them correctly.
K
Handles
L
Remote controller
A / B
Hard case/Control panel
M
Battery
D
Trim plate
*
1
When you stand the unit, be careful not
to damage the fuse on the rear.
Do the required electrical connections.
Bend the appropriate tabs to hold the
sleeve firmly in place.
N
Reverse gear signal extension cord
Do not block the fan.
1
The following illustration shows a typical installation. If you have any questions or require information
regarding installation kits, consult your JVC car audio dealer or a company supplying kits.
• If you are not sure how to install this unit correctly, have it installed by a qualified technician.
• Make sure not to block the fan on the rear panel to maintain proper ventilation when installed.
Required space for installation
• You cannot install the unit on the car which has any obstacles in the space indicated below.
Control panel
Trim plate is detached on this
illustration for explanation.
Dashboard
Caution when installing
Fit the unit into the mounting sleeve by using four corners of the
trim plate.
• DO NOT press the panel (shaded in the illustration).
INSTALLATION (IN-DASH MOUNTING)
Install-1_KD-AVX11[A].indd 1Install-1_KD-AVX11[A].indd 1 07.1.8 11:56:04 AM07.1.8 11:56:04 AM
To Next Page
Need help?
General
