20
DISPLAY SETTINGS
KD-R85MBS / KD-AR855BT / KD-R850BTKD-AR959BS / KD-R950BT
1 Press and hold MENU.
2 Turn the volume knob to make a selection (see the following table),
then press the knob.
Repeat step
2 until the desired item is selected.
3 Press MENU to exit.
To return to the previous setting item or hierarchy, press PTY.
Default:
XX
DISPLAY
DIMMER
Selects the display and button illumination adjusted in the
[BRIGHTNESS]
setting.
AUTO
:Changes between the day and night adjustments when you turn off
or on the car headlights. *
1
;
ON
:Selects the night adjustments.;
OFF
:Selects
the day adjustments.
BRIGHTNESS
Sets the button, display and USB input terminal brightness for day and night
separately.
1
DAY
/
NIGHT
:Select day or night.
2
Select a zone for setting.
( Illustration above)
3
Set the brightness level (
00
to
31
). (Default:
DAY
:
31
;
NIGHT
:
15
)
SCROLL
*
2
ONCE
:Scrolls the display information once.;
AUTO
:Repeats scrolling at
5-second intervals.;
OFF
:Cancels.
*
1
The illumination control wire connection is required.
( 27, 28)
*
2
Some characters or symbols will not be shown correctly (or will be blanked).
HPF
*
3
OFF
:All signals are sent to the front/rear speakers.;
LOW
100Hz
/
MID
120Hz
/
HIGH150Hz
:Audio signals with frequencies lower than
100Hz/ 120Hz/ 150Hz are cut off from the front/rear speakers.
FADER
*
4
*
5
R06
—
F06
(
00
):Adjusts the front and rear speaker output balance.
BALANCE
*
4
L06
—
R06
(
00
):Adjusts the left and right speaker output balance.
VOL
ADJUST –05
—
+05
(
00
):Presets the volume adjustment level of each source
(compared to the FM volume level). Before adjustment, select the source
you want to adjust. (“VOLADJFIX” appears if FM is selected.)
AMP
GAIN LOW
POWER
:Limits the maximum volume level to 30. (Select if the
maximum power of each speaker is less than 50W to prevent damaging
the speakers.);
HIGHPOWER
:The maximum volume level is 50.
D.T.EXP
(Digital Track
Expander)
ON
:Creates realistic sound by compensating the high-frequency
components and restoring the rise-time of the waveform that are lost in
audio data compression.;
OFF
:Cancels.
L/O
MODE
*
6
SUB.W
/
REAR
:Selects whether rear speakers or a subwoofer are
connected to the REAR/SW line out terminals on the rear panel (through an
external amplifier).
*
3
For
KD-AR959BS
/
KD-R950BT
/
KD-R85MBS
/
KD-AR855BT
.
*
4
This adjustment will not affect the subwoofer output.
*
5
If you are using a two-speaker system, set the fader level to
[00]
.
*
6
For
KD-R950BT
/
KD-R850BT
.
AUDIO SETTINGS
To Next Page
Loading...
Need help?
General
