ENGLISH
11
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
Pair and connect a Bluetooth device for the first time
1
Press (for
KD-R981BT
/
KD-R784BT
/
KD-R782BT
) or (for
KD-R889BT
/
KD-R881BT
) to
turn on the unit.
2 Search and select “KD-R9 BT”/“KD-R8 BT”/“KD-R7 BT” on the Bluetooth device.
“BTPAIRING” flashes on the display.
• For some Bluetooth devices, you may need to enter the Personal Identification Number (PIN)
code immediately after searching.
3 Perform (A) or (B) depending on what appears on the display.
For some Bluetooth devices, pairing sequence may vary from the steps described below.
(A) “[Device Name]”
“XXXXXX” “VOL–YES” “BACK–NO” (for
KD-R981BT
/
KD-R784BT
/
KD-R782BT
) or “ENTER–YES” “BACK–NO” (for
KD-R889BT
/
KD-R881BT
).
“XXXXXX” is a 6-digit passkey randomly generated during each pairing.
Ensure that the passkeys appear on the unit and Bluetooth device are the same.
Press the volume knob (for
KD-R981BT
/
KD-R784BT
/
KD-R782BT
) or (for
KD-R889BT
/
KD-R881BT
) to confirm the passkey.
Operate the Bluetooth device to confirm the passkey.
(B) “[Device Name]” “VOL–YES” “BACK–NO” (for
KD-R981BT
/
KD-R784BT
/
KD-R782BT
) or
“ENTER–YES”
“BACK–NO” (for
KD-R889BT
/
KD-R881BT
).
Press the volume knob (for
KD-R981BT
/
KD-R784BT
/
KD-R782BT
) or (for
KD-R889BT
/
KD-R881BT
) to start pairing.
• If “PAIRING” “PIN 0000” scrolls on the display, enter the PIN code “0000” into the
Bluetooth device.
You can change to a desired PIN code before pairing.
( 16)
• If only “PAIRING” appears, operate the Bluetooth device to confirm pairing.
“PAIRING COMPLETED” appears when pairing is completed and “ ” will light up when the Bluetooth
connection is established.
• This unit supports Secure Simple Pairing (SSP).
• Up to five devices can be registered (paired) in total.
• Once the pairing is completed, the Bluetooth device will remain registered in the unit even if you
reset the unit. To delete the paired device,
16
,
[DEVICE DELETE]
.
• A maximum of two Bluetooth phones and one Bluetooth audio device can be connected at any
time.
However, while in BT AUDIO source, you can connect to five Bluetooth audio devices and switch
between these five devices. (
17
)
BLUETOOTH®
BLUETOOTH — Connection
Supported Bluetooth profiles
– Hands-Free Profile (HFP)
– Advanced Audio Distribution Profile (A2DP)
– Audio/Video Remote Control Profile (AVRCP)
– Serial Port Profile (SPP)
– Phonebook Access Profile (PBAP)
Supported Bluetooth codecs
– Sub Band Codec (SBC)
– Advanced Audio Coding (AAC)
Connect the microphone
Adjust the
microphone angle
Secure using cord clamps
(not supplied) if necessary.
Microphone input jack
Microphone (supplied)
Rear panel
JS_JVC_KD_R981_E_EN_5.indd 11JS_JVC_KD_R981_E_EN_5.indd 11 9/1/2016 2:06:13 PM9/1/2016 2:06:13 PM
To Next Page
Loading...
Need help?
General
Weight and Dimensions
