JVC KD-S100 User Manual

Maintenance
• How to clean the connectors
Frequent detachment will deteriorate the connectors.
To minimize this possibility, periodically wipe the
connectors with a cotton swab or cloth moistened with
alcohol, being careful not to damage the connectors.
• To keep discs dean
A dirty disc may not play correctly. ~.
If a disc does become dirty, wipe it with .,
a soft cloth in a straight line from center
to edge.
• Do not use any solvent (for example, conventional
record cleaner, spray, thinner, benzine, etc.) to clean
discs.
Center holder
Connector
Do not use the following dis(s:
Warped disc -#
• How to handle SO card
SD cards are precision products. DO NOT impact, bend,
drop, or wet them.
* Stick-on label
Sticker. Sticker residue
• To play new discs
New discs may have some rough spots
around the inner and outer edges. If
such a disc is used, this unit may reject
the disc.
To remove these rough spots, rub the edges with a
pencil or ball-point pen, etc.
When removing a dis( from its
(ase, press down the center holder
of the case and lift the disc out,
holding it by the edges.
• Always hold the disc by the edges. Do not touch its
recording surface.
When storing a dis( into its (ase, gently insert the
disc around the center holder (with the printed surface
facing up).
• Make sure to store discs into the cases after use.
• How to handle discs
• Moisture condensation
Moisture may condense on the lens inside the unit in
the folloWing cases:
• After starting the heater in the car.
• If it becomes very humid inside the car.
Should this occur, the unit may malfunction. In this
case, eject the disc and leave the unit turned on for a
few hours until the moisture evaporates.

JVC KD-S100 Specifications

General

Brand	JVC
Model	KD-S100
Category	Car Receiver
Language	English