JVC KD-S12 User Manual

KD-S12
Installation/Connection Manual
Manual de instalación/conexión
GET0317-002A
[J]
0705DTSMDTJEIN
EN, SP
J
Handles
F
Washer (ø5)
G
Lock nut (M5)
H
Mounting bolt—
M5 x 20 mm (M5 x 13/16")
I
Rubber cushion
A / B
Hard case/Control panel
C
Sleeve
D
Trim plate
E
Power cord
Do the required electrical connections.
Bend the appropriate tabs
to hold the sleeve firmly in
place.
Parts list for installation and connection
INSTALLATION (IN-DASH MOUNTING)
If you are not sure how to install this unit correctly, consult your JVC car audio dealer.
Removing the unit
Before removing the unit, release the rear section.
ENGLISH
You need the installation kits which corresponds to your car.
• Mark all the check boxes (
) to make sure you have follow the instructions and the listed
parts.
12 V DC, NEGATIVE ground
1
When using the optional stay
Screw (option)
Stay (option)
Fire wall
Dashboard
Install the unit at an
angle of less than
30˚.
When installing the unit without
using the sleeve
In a Toyota for example, first remove the car
radio and install the unit in its place.
Bracket
Flat type screws—
M5 x 8 mm (M5 x 3/8")
Flat type screws—
M5 x 8 mm (M5 x 3/8")
Check the battery system in your car.
Bracket
Instal_EN_KD-S12[J]f.indd 2Instal_EN_KD-S12[J]f.indd 2 6/30/05 4:07:59 PM6/30/05 4:07:59 PM

JVC KD-S12 Specifications

General

Brand	JVC
Model	KD-S12
Category	Car Receiver
Language	English