ENGLISH
15SETTINGS
Sound and monitor settings
Selecting a sound mode
You can select a preset sound mode suitable to the
music genre.
• Preset value for each sound mode is as follows:
Mode
Bass
(BAS)
Treble
(TRE)
Loudness
(LOUD)
ROCK +2 +3 ON
POPS +3 +1 OFF
CLASSIC +1 -3 OFF
FLAT 0 0 OFF
EQ OFF
(Canceled)
00—
• Sound mode is automatically canceled (“EQ OFF” is
selected) in the following cases:
– When activating/deactivating loudness (see
“Activating loudness” below).
– When adjusting bass/treble setting (see “Adjusting
the sound settings” on the right column).
Activating loudness
You can boost low and high frequencies to produce a
well-balanced sound at low volume level.
Loudness is activated and “LOUD ON” appears on
the display.
To cancel loudness, press the button again. “LOUD
OFF” appears on the display.
Adjusting the sound settings
You can adjust the sound characteristics to your
preference.
1
2
VOL Adjusts the volume. (0 to 50)
BAS Adjusts the bass. (–6 to +6)
TRE Adjusts the treble. (–6 to +6)
BAL Adjusts the left and right speaker balance.
(L6 to R6)
FAD*
2
Adjusts the front and rear speaker balance.
(R6 to F6)
ADJ*
1
Adjusts the output level of the external
component. (0 to 3)
*
1
This item is shown only when “AUX IN” is selected as
the source.
*
2
If you are using a two-speaker system, set the fader
level to “0.”
Selecting the color system
Select the appropriate color system according to the
type of the monitor connected.
While playing a VCD...
The setting appears on the monitor.
PAL For the PAL monitor
NTSC For the NTSC monitor
PAL60 For watching an NTSC disc on a PAL monitor
AUTO Automatically selects the appropriate color
system.
PAL NTSC PAL60
AUTO
[Turn]
EN_KD-SV3706[US].indb 15EN_KD-SV3706[US].indb 15 08.12.11 3:10:11 PM08.12.11 3:10:11 PM
To Next Page
Loading...
Need help?
General
