EasyManuals Logo
Home>JVC>Car Receiver>KD-SX979R

JVC KD-SX979R User Manual

JVC KD-SX979R
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
17
ENGLISH
Changing the display mode while listening to an FM
station
You can change the initial indication on the display to either station name (PS NAME) or to
station frequency (FREQ), while listening to an FM RDS station.
See also “Changing the general settings (PSM)” on page 27.
1. Press and hold SEL (select) for more than 2 seconds so that one of the PSM items appears
on the display.
2. Select “TU DISP (tuner display)” with
¢ or 4.
3. Set to the desired indication (“PS NAME” or “FREQ”) with the control dial.
Note:
By pressing DISP, you can also change the display while listening to an FM RDS station.
Each time you press the button, the following information appears on the upper part of the display:
* Then, the display goes back to the original indication in several seconds.
Setting the TA volume level
You can preset the volume level for TA Standby Reception. When a traffic programme is
received, the volume level automatically changes to the preset level.
See also “Changing the general settings (PSM)” on page 27.
1. Press and hold SEL (select) for more than 2 seconds so that one of the PSM items appears
on the display.
2. Select “TA VOL (volume)” with
¢ or 4.
3. Set to the desired volume with the control dial.
Automatic clock adjustment
When shipped from the factory, the clock built in this unit is set to be readjusted automatically
using the CT (Clock Time) data in the RDS signal.
If you do not want to use automatic clock adjustment, follow the procedure below.
See also “Changing the general settings (PSM)” on page 27.
1. Press and hold SEL (select) for more than 2 seconds so that one of the PSM items appears
on the display.
2. Select “AUTO ADJ (adjust)” with ¢ or 4.
3. Select “OFF” by turning the control dial counterclockwise.
Now automatic clock adjustment is canceled.
To reactivate clock adjustment, repeat the same procedure and select “ON” in step 3 by
turning the control dial clockwise.
Note:
It takes about 2 minutes to adjust the time using the CT data. So, you must tune to the station for more
than 2 minutes continuously; otherwise, the clock time will not be adjusted.
Station FrequencyPS (Station name) PTY (Programme type)
EN10-17.KD-SX979R[E]/f 00.1.20, 2:00 PM17

Table of Contents

Other manuals for JVC KD-SX979R

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JVC KD-SX979R and is the answer not in the manual?

JVC KD-SX979R Specifications

General IconGeneral
BrandJVC
ModelKD-SX979R
CategoryCar Receiver
LanguageEnglish

Related product manuals