12
ENGLISH
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
Pair and connect a Bluetooth device for the first time
1
Press source button to turn on the unit.
2 Search and select the name of your receiver (“KD-T8 BT”/“KD-T7 BT”) on the Bluetooth
device.
“BT PAIRING” flashes on the display.
• For some Bluetooth devices, you may need to enter the Personal Identification Number (PIN)
code immediately after searching.
3 Perform (A) or (B) depending on what appears on the display.
For some Bluetooth devices, pairing sequence may vary from the steps described below.
(A) KD-T801BT/KD-T709BT:
“Device Name” “XXXXXX” “ENTER–YES” “BACK–NO”
KD-T706BT/KD-T702BT:
“Device Name” “XXXXXX” “VOL–YES” “BACK–NO”
“XXXXXX” is a 6-digit passkey randomly generated during each pairing.
Ensure that the passkeys appear on the unit and Bluetooth device are the same.
Press the following to confirm the passkey.
KD-T801BT/KD-T709BT: * ENTER
KD-T706BT/KD-T702BT: Volume knob
Operate the Bluetooth device to confirm the passkey.
(B) KD-T801BT/KD-T709BT:
“Device Name” “ENTER–YES” “BACK–NO”
KD-T706BT/KD-T702BT:
“Device Name” “VOL–YES” “BACK–NO”
Press the following to start pairing.
KD-T801BT/KD-T709BT: * ENTER
KD-T706BT/KD-T702BT: Volume knob
• If “PAIRING” “PIN 0000” scrolls on the display, enter the PIN code “0000” into the
Bluetooth device.
You can change to a desired PIN code before pairing. (Page 17)
• If only “PAIRING” appears, operate the Bluetooth device to confirm pairing.
“PAIRING COMPLETED” appears when pairing is completed and “” will light up when the Bluetooth
connection is established. For KD-T801BT/KD-T709BT, the battery and signal strength of the
connected Bluetooth device is shown (see
[FORMAT]
on page 26).
BLUETOOTH®
Depending on the operating system and the
firmware version of your mobile phone, Bluetooth
features may not work with this unit.
BLUETOOTH — Connection
Supported Bluetooth profiles
– Hands-Free Profile (HFP)
– Advanced Audio Distribution Profile (A2DP)
– Audio/Video Remote Control Profile (AVRCP)
– Serial Port Profile (SPP)
– Phonebook Access Profile (PBAP)
Supported Bluetooth codecs
– Sub Band Codec (SBC)
– Advanced Audio Coding (AAC)
Connect the microphone
Adjust the microphone
angle
Secure using cord clamps (not
supplied) if necessary.
Microphone input jack
Microphone (supplied)
Rear panel
JS_JVC_KD_T801BT_E_EN_05.indd 12JS_JVC_KD_T801BT_E_EN_05.indd 12 6/4/2018 9:41:19 AM6/4/2018 9:41:19 AM
To Next Page
Loading...
Need help?
General
