Controlling Audio
73English
Controlling General Audio
1
Press the [FNC] button.
Popup menu appears.
2
Touch [ ].
HOME screen appears.
3
Touch [ ].
Source selection screen appears.
4
Touch [Audio].
Audio screen appears.
5
Touch [Fader / Balance].
6
Set each item as follows.
■ [Fader / Balance]
Adjust the volume balance around the
touched area.
[C] and [D] adjust the right and left volume
balance.
[R] and [S] adjust the front and rear volume
balance.
■ [Center]
Clear the adjustment.
Equalizer Control
You can adjust equalizer by selecting the
optimized setting for each category.
1
Press the [FNC] button.
Popup menu appears.
2
Touch [ ].
HOME screen appears.
3
Touch [ ].
Source selection screen appears.
4
Touch [Audio].
Audio screen appears.
5
Touch [Equalizer].
6
Touch the screen and set the Graphic
Equalizer as desired.
■ Gain level (dotted frame area)
Adjust the gain level by touching the each
frequency bar.
You can select frequency bar and adjust its
level by [R], [S].
■ [Preset Select]
Displays the screen to recall the preset
equalizer curve.
■ [Memory]
Saves the adjusted equalizer curve from
“User1” to “User4”.
■ [Initialize]
The current EQ curve returns to flat.
■ [ALL SRC]
Apply the adjusted equalizer to all sources.
Touch [ALL SRC] and then touch [OK] on the
confirmation screen.
■ [Bass EXT] (Bass Extend Settings)
When turned on, the frequency lower than
62.5 Hz is set to the same gain level as 62.5
Hz.
■ [SW Level]
Adjusts the subwoofer volume. This setting
is not available when subwoofer is set to
“None”. See Speaker/ X’over setup (P.71).
!B5A-2303-00b_18KWV-K_En.indb 73 2018/01/09 18:26
To Next Page
Loading...
Need help?
General
