1-10 (No.49784)
3.2.3 Removing the CD mechanism assembly
(See Fig.1, 6 to 9)
• Prior to performing the following procedure, remove the CD
mechanism control board and the front bracket (loading mo-
tor).
(1) Remove the three screws D and the damper bracket.
(2) Raise the both sides fix arms and move the fix plates in the
direction of the arrow to place the four shafts g as shown in
Fig.8 and 9.
(3) Remove the CD mechanism assembly and the two springs
h attaching the flame.
(4) Remove the two screws E and both sides rear damper
brackets from the dampers. Detach the CD mechanism as-
sembly from the left side to the right side.
ATTENTION:
The CD mechanism assembly can be removed if only the rear
damper bracket on the left side is removed.
Fig.1
Fig.6
Fig.7
Fig.8
Fig.9
Front bracket
CD mechanism
control board
Damper bracket
h
c
d
b
a
D
D
D
CD mechanism assembly
A
e
h
D
D
Damper bracket
CD mechanism
assembly
Flame
h
D
D
Fix plate (L)
g
g
Rear damper bracket
Fix arm (L)
Damper
E
Rear damper bracket
Fix arm (R)
Damper
Fix plate(R)
E
g
g
w
w
w
.
x
i
a
o
y
u
1
6
3
.
c
o
m
Q
Q
3
7
6
3
1
5
1
5
0
9
9
2
8
9
4
2
9
8
T
E
L
1
3
9
4
2
2
9
6
5
1
3
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
http://www.xiaoyu163.com
http://www.xiaoyu163.com
To Next Page
Loading...
Need help?
General
