8
Installing / Removing the Base Stand
The LCD display is very fragile, and must be protected at all times when installing and removing the base stand. Be sure that
no hard or sharp object, or anything that could scratch or damage the LCD display, comes into contact with it. DO NOT exert
pressure on the front of the TV at any time because the screen could crack.
Fitting the Stand
1. Ensure the TV is switched off and not connected to the mains power supply.
2. Lay the TV down on a flat surface ideally on the edge of a table so the base of the TV slightly overhangs the edge of the table,
with the back side facing up. Please make sure a soft cushioned material (such as a dry bath towel or thick piece of foam) is
placed beneath the screen.
3. Fit each leg to your TV using the screws supplied.
SPDIF
Optic.OUT
VGA
ANT.
HDMI 2
(ARC)
LAN
AV IN
SPDIF
Optic.OUT
VGA
ANT.
HDMI 2
(ARC)
LAN
AV IN
TableCushioned
material
Protective
bag
JVC 32' LED Smart HD TV LT-32C600 Manual.indd 8JVC 32' LED Smart HD TV LT-32C600 Manual.indd 8 23/12/2020 14:4123/12/2020 14:41
To Next Page
Loading...
Need help?
General
