15
3 Initial Setup
Turning the TV On for the First Time
1. Connect one end of the RF coaxial cable to the aerial
socket on the wall and the other end of the cable to
the ANT socket on the back of your TV.
2. Plug the TV into a mains socket and switch on at the
mains.
3. In standby mode, press the
button on the remote
control to turn the TV on. The LED indicator will flash
for a few seconds then the TV will switch on.
Do not connect the TV to the mains supply until you have
completed all the connections.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The
button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the
mains power. To completely disconnect the mains power, please remove the mains plug from the mains socket.
Chapter
3
4. The first time you turn the TV on, it will go straight
into the First Time Installation menu. Please ensure
the aerial is plugged in.
Press the
buttons to highlight your language
then press OK.
5. Press the buttons to select your country.
6. Press the
button to highlight Teletext Language,
then press the
buttons to select your language.
The majority of people will want this set to West.
7. Press the
button to highlight Scan Encrypted (pay-
per-view) Channel, then press the
buttons to
select On or Off.
Select Broadcast Type
In this section you can tell your TV what to tune in.
Digital Aerial is TV through your aerial (Freeview) this is automatically set to On for UK customers.
Cable is if you have cable wired directly into your TV NOT through a set top box like Virgin.
Analogue is for analogue devices that you may have connected to your TV e.g. a video recorder.
8. Press the
button to highlight Digital Aerial, then
press the
buttons to select On or Off. On will only
search for the digital channels.
9. Press the
button to highlight Select favourite
network type, then press the
buttons to select
Digital Aerial, Digital Cable or Analogue. This can
only be chosen if you have selected more than one
Broadcast type. Confirm these settings by pressing
OK.
SCART
SPDIF
Coax.OUT
VGA
ANT.
HDMI 1
(ARC)
HDMI 2
LAN
SCART
SPDIF
Coax.OUT
VGA
ANT.
HDMI 1
(ARC)
HDMI 2
LAN
RF coaxial cable
(not included)
To Next Page
Loading...
Need help?
General
