English - 1 -
1
Inserting the batteries into the remote
The remote may have a screw that secures the battery compartment cover onto the remote control (or this may
be in a separate bag). Then remove the battery compartment cover to reveal the battery compartment. Insert
two 1.5V size AAA batteries. Make sure the (+) and (-) signs match (observing correct polarity). Do not mix old
-or-
the cover gently. Insert two 1.5V - size AAA batteries. Make sure the (+) and (-) signs match (observe correct
polarity). Do not mix old and new batteries. Replace only with same or equivalent type. Place the cover back
on. Then screw the cover back on again.
-or-
Remove the back cover to reveal the battery compartment. You need to do the followings in order to do that:
Place the tip of a pen or some other pointed object in the hole above the cover and press it down.
Insert two 1.5V - size AAA batteries. Make sure the (+) and (-) signs match (observe correct polarity). Do not
mix old and new batteries. Replace only with same or equivalent type. Place the cover back on.
2
Connections
Antenna
Connect the antenna cable/s to your TV.
satellite
dish
aerial /
cable TV
External Devices
To select the desired input source, press the Source
button on the remote control.
HDMI connection
rear side or rear-left
side of TV
Power
After unpacking, allow the TV set to reach the ambient room temperature before you
connect the set to the mains. Plug the power cable to the mains socket outlet.
IMPORTANT: The TV set is designed to operate on a 220-240V AC, 50 Hz supply.
To Next Page
Loading...
Need help?
General
