10
Connections
Stereo Chain Connections
To create a stereo chain connection, you need to have two megatower hi- systems.
True Wireless (TWS) Connection
1. Switch both hi- systems in BT (Bluetooth) mode.
2. Press the STEREO CHAIN button on both the speakers at the same time. Both units will
display PARTY SELECT.
3. Press
/ button to select between HOST and SLAVE for each unit. The SLAVE unit
will prompt a beep tone to indicate that both units are now connected.
4. Enable your Bluetooth device and make sure it is in searching mode.
5. Select “MX-D719PB” and enter “0000” for the password if necessary.
6. The master speaker will act as the left channel during TWS and will receive the
Bluetooth signal, the other speaker will act as the right channel to play music.
Press and hold the STEREO CHAIN button to disconnect the TWS connection.
Connecting a Mobile Device
Connect the LINE IN (AUX IN) socket of the main unit to the headphone jack on a mobile
device (not included) with a 3.5 mm to 3.5 mm stereo audio cable illustrated below.
BOO STE R
STER EO
CHAI N
TUNE
TUNE
PAIR
LINE IN
3.5mm to 3.5mm
stereo audio cable
(included)
Top View of the Main Unit
Mobile Devices
MX-D719PB_IB_Final190704V2.indd 10 05/07/2019 09:48
To Next Page
Loading...
Need help?
General
