11
Setting the Clock and Daily Timer
Setting the Clock
• To go back to the previous step, press CANCEL.
• If there is a power failure, the clock loses the setting and is reset to “0:00”. You need to set the
clock again.
Setting the Daily Timer
Without setting the built-in clock, you cannot use Daily Timer.
Using Daily Timer, you can wake up with music, etc.
Connect the iPod or USB mass storage device, or other equipment, to the Unit beforehand. (P.13,
P.15, P.19)
• To exit from the timer setting, press CLOCK/TIMER as required.
• To correct a misentry during the process, press CANCEL. You can return to the previous step.
1
Activate the clock setting mode (“Clock Adjust” appears).
The hour digit of the time indication blinks on the display.
• If you have already adjusted the clock before, press the button repeatedly
until “Clock Adjust” appears.
If the clock has not been adjusted, “Clock Adjust” appears first.
2
1 Adjust the hour. The minute digits of the time indication blink
on the display.
2 Adjust the minute. The built-in clock starts working.
1
Select the timer setting mode.
2
1 Adjust the hour then the minute for Daily Timer on-time.
2 Adjust the hour then the minute for Daily Timer off-time.
• The on-time and off-time of the Daily Timer cannot be set to the same time.
3 Select the playback source—“iPod,” “USB MEMORY,” or “AUX.”
• If “USB MEMORY” is selected, select the GROUP number (“001” to
“500” and “---”) and then select the TRACK number (“001” to “999”
and “---”).
If you select “---,” TRACK1 in GROUP1 is set.
4 Select the volume level (“VOLUME MIN / 1 to 29 / VOLUME MAX”).
“SET OK” appears briefly followed by setting information, then the
icon appears on the display.
3
Turn off the System (on standby).
Current timer settings
Canceled
Timer setting Clock Adjust
or
(Twice)
Current timer settings
Timer setting
Canceled
Clock Adjust
or
NX-PS1[B].BOOK Page 11 Monday, October 30, 2006 9:26 AM
To Next Page
Loading...
Need help?
General
